Winter exposes the weak spots in a backup plan. A generator that won't start. A furnace that won't light without power. A battery left empty in a closet. Five HoldBackup guides cover what to check while the grid is still up.

Markets move. Headlines catastrophize. Inside the noise is the story that matters — the opportunity, not the fear. The Daily Upside: global business and finance, reported without the alarm.

Thick oil, stale fuel and a weak starter battery are the usual reasons a generator won't start on a frozen morning. Carbon monoxide is the risk that kills. Run it outdoors only, away from windows, doors and vents. An open garage door does not make a garage safe.

Do this: Switch to the cold-weather oil grade in the owner's manual, add fresh fuel with stabilizer, and test battery-powered carbon monoxide alarms inside.

A gas furnace still needs electricity to light and move air. The blower, inducer fan, igniter and control board all need electricity. Most furnaces are hardwired, so the connection is an electrician's job.

Do this: Read the furnace nameplate, or have an electrician measure running draw with a clamp meter. Look for pure sine wave output, then test a full heating cycle on a mild day.

Watts decide whether a station can run the heater. Watt-hours decide how long. Heaters use up capacity quickly. For heat through a whole night, a generator run safely outdoors is often the better fit.

Do this: Divide the station's watt-hours by the heater's label watts on the setting you'll use, then plan for less. Heat one small closed room on the lowest setting, and don't leave it running while you sleep.

A battery left empty for months can drain so low it won't wake up. One held full on the charger wears faster. The manual sets the storage charge level, temperature range and recharge interval.

Do this: Keep it in an indoor closet, not an attic, car or unheated shed. Set a phone reminder for the recharge interval. When a storm is forecast, charge it fully and run one real load briefly.

A UPS can seem fine with a worn battery inside. The built-in self-test can find faults, but it doesn't show outage runtime.

Do this: Save your work, run the self-test as the manual describes, and compare runtime at your load with the maker's chart. Don't improvise a test by pulling the wall plug. If the case is swollen, leaking, hot or smells odd, stop using it and contact the maker.

Guides on HoldBackup can link to stores and may earn a commission; each guide says so where it does. How HoldBackup makes money

HoldBackup Team

490 Post St Ste 500 PMB 2028, San Francisco, CA 94102